Mount file as partition

First you need to identify the disk. The disks paths are available under the 'DeviceID' columns. Mount the disk - Using PowerShell, you can mount the disk using the Disk path discovered above, run:. If you have a disk that you aren't sure what file format it is in, or what partitions it has, you can follow the steps below to mount it. List and select the partitions to mount in WSL 2 - Once the disk is identified, run:.

This will make the disk available in WSL 2. If you wish to mount the entire disk as a single volume i. Once mounted, the disk can be accessed under the path pointed to by the config value: automount. Be sure to run this command with administrator privileges. Below is an example where we use this command, and also output the disk path. You can use the output above to obtain the disk path for this VHD and mount that into WSL following the instructions in the previous section.

You can also use this technique to mount and interact with the virtual hard disks of other WSL distros, as each WSL 2 distro is stored via a virtual hard disk file called: ext4. Make sure to run wsl --shutdown before interacting with this disk to ensure the disk is not in use.

Only filesystem specific options are supported at this time. Generic options such as ro, rw, noatime, If the disk scheme isn't supported by any of the above options, you can attach the disk to WSL 2 without mounting it by running:.

This will make the block device available inside WSL 2 so it can be mounted manually from there. Partition manipulation is crucial in a Linux system, and next, we recommend learning how to delete a partition in Linux and how to format disk partitions in Linux. Was this article helpful?

Nevena Pavlicic. She has always enjoyed researching and building knowledge on cutting edge technologies, but she is also passionate about simplifying complex concepts.

Next you should read. Bare Metal Servers SysAdmin. Creating and deleting partitions in Linux is common because users must structure storage devices DevOps and Development SysAdmin.

The ls command short for 'list' lists information about directories and any type of files in the working SysAdmin Web Servers. A list of all the important Linux commands in one place. In fact, there is no need to worry. Because the missing partition caused by Windows 10 Anniversary Update is still on the computer, but there is something wrong with its partition table.

As a result, you cannot see it. On the other hand, if you still worry about data loss problems, you may try MiniTool Power Data Recovery since it can help to effectively recover data that have been lost in a variety of ways.

As long as file loss is not caused by hardware failure and lost files are not overwritten by new data, you are able to recover them with this tool. If you have any other question to solve the hard drive missing after Windows 10 update issue, please share it with us by leaving a comment below.

Much appreciated! Summary : Partition disappears in Windows 10 anniversary update? This post lists 3 ways to help you find the missing hard drive space in Windows 10 Quick Navigation :.

Note: You should pay special care when changing the letter of a system partition as changing the letter of a system partition may cause your computer not to boot properly. Note: Please make sure you have checked all partitions you need, for the unchecked one will be deleted after partition recovery. I Doser Free Download ».